Unpacking
We carefully packaged your printer , to protect it from rough handling usually involved with international freight.
Therefore, if despite our efforts, you are being delivered a damaged package you should always refuse delivery
or put your remarks on the delivery bill.
During unpacking, NEVER use cutters: you risk piercing the packaging, therefore damaging content.
Follow this procedure:
1. Remove plastic straps, using scissors. To open wooden box, don't use crowbars: use a screwdriver
to remove cover and side panels
2. Remove cover
3. Remove packaging foam/bubbles
4. Remove packaging side panels
5. If a pedestal has been delivered, assemble it taking care to tighten ALL the bolts.
6. If you didn't buy a pedestal, be sure to select a desk/table that will be sturdy enough to support the
printer
7
Fig. 1: Shipping packaging removed
To Next Page
Loading...
