Setting the switch-on time
Use [ ] and [ ] to set the day. In the example this is SU.
Confirm with [ENTER].
The cursor moves to the hour digits, which will blink.
Use [ ] and [ ] to set the switch-on hour to the desired value. In the example, this
is 08.
Confirm with [ENTER].
The cursor moves to the minute digits, which will blink.
Note
Because the switch-off time can never be earlier than the switch-on time, the switch-off
time setting is automatically adjusted with the switch-on time.
Use [ ] and [ ] to set the minutes. In the example, this is 15. Confirm with
[ENTER].
The cursor moves to the hour digits of the switch-off period.
Setting the switch-off time
Use [ ] and [ ] to set the hours. In the example, this is 012.
Confirm with [ENTER].
The cursor moves to the minute digits, which will blink.
Use [ ] and [ ] to set the minutes.In the example, this is 45.
Confirm with [ENTER].
The cursor moves to the water temperature. See the figure
Setting the water temperature
Use [
] and [ ] to set the water temperature. In the example this is 75°C.
Confirm with [ENTER].
The cursor moves to PUMP ON
Setting the program-controlled pump
If required, a pump can be controlled during the period. Use [ ] and [ ] to set
PUMP ON. The pump ensures a regular circulation of hot water in the hot water
pipes. You can skip this step if you there is no pump in your hot water circuit.
Confirm with [ENTER].
3.
4.
n
5.
6.
7.
8.
9.
0311704_BFC_28-120_III_ENEN_V2.4, 2022-10-17 37
To Next Page
Loading...
