AAON Airflow - 5.2.3. Factory Defaults

18
5.2.3. Factory Defaults
If parameter configuration changes have been made incorrectly to the AAON Airflow Signal Processor,
all device settings can be restored to the original AAON factory settings by selecting YES and pressing
Enter in both the Set To Factory Defaults Menu and the Verify Set To Factory Defaults Menu (see
Factory Defaults table below for a list of Saved Settings).
Field Setup
Menu

Output Filter
Set To
Verify Set To
Alarm Options
Factory Defaults

Factory Defaults
Factory Defaults
Output Filter

(No)
(No)
FACTORY DEFAULTS
ITEM
SAVED SETTING
ITEM
SAVED SETTING
1
All Factory Calibration Points (12)
14
MAC Address
2
Area Factor
15
Instance Number
3
Operating Range
16
Engineering Units
4
4 Pt Flow Correction
17
Display Filter Values
5
Altitude
18
Output Filter
6
K-Factor
19
DP Display Format
7
Lockdown & Delay Values
20
Output Calibration
8
Flow Correction
21
AutoZero Status
9
Flow Coefficient
22
AutoZero Interval
10
Min. & Max. Temp Range Values
23
Temp. Units
11
Alarm Status
24
Temp. Input
12
Alarm Values
25
Temp. Fixed Value
13
Alarm Delay
26
Baud Rate