Personalizing your phone
110 Aastra 5370/Aastra 5370ip
eud-1281/1.3 – R3.0 – 04.2013
Configuring Line Keys
This section explains how to adapt your Line key settings to suit your personal
requirements.
Your system administrator will determine whether your phone has Line keys.
Setting the Response of a Line Key
You want to set the response of a line key.
You can choose whether you also want a ringing signal in addition to the flashing Line
key when you receive a call on a Line key. You can configure a ringing delay for the
ringing tone.
To answer a call you can choose between answering directly by pressing the Line key,
picking up the handset, and using automatic hands-free operation.
Answering an external call using automatic hands-free operation is not available.
The following audio settings are possible: Ring, Melody, Speed, Answer.
Notes:
• A Line key can only be allocated to a configurable key.
• To find out how to use a line key, refer to the Chapter "Line keys", page 81.
<long>
Press the Line key you want and hold it down for a moment.
➔The display shows the Line key and the properties with which you can con-
figure the Line key.
Note:
The Personal key is also treated as a line key.
Line key
Scroll to Line key and press the Select Foxkey.
<Audio setting>
Set the Audio settings:
Scroll to the required audio settings and press the Modify Foxkey. Select the
required setting and confirm with the Ok Foxkey.
➔The setting is stored.
Setting possibilities for ringing:
• Off for no ringing tone, On for instant ringing tone After10s, After20s and
ringing tone After30s and confirm with Ok Foxkey.
• You can listen to each setting using the Test Foxkey.
To Next Page
Loading...
