Remote-Controlled Functions
101
Deleting the Function
Using the call number reserved in the OpenCom 100 / Aastra 800 for remote control,
you can configure or delete call forwarding “Immediate” for your own call number
from a remote location. This remotely-programmed forwarding overwrites any other
existing call forwarding. Call forwarding “On Busy” and “After Delay” are not affected.
Incorrect or non-existent call numbers are rejected. Your authorisation is checked in
the same way as for call forwarding within the OpenCom 100 / Aastra 800.
A correct entry is confirmed with a positive acknowledgement signal, provided the
system administrator has not deactivated this function (in the Configurator,
Telephony: Settings menu). The external call is subsequently ended.
Note
The procedure is aborted if there is a pause of longer than 60 seconds between the
entry of two digits. With this duration, remote-controlled functions using GSM cell
phones can also be realised.
Remote-Programmable Voicebox Configuration
and Query
If the system administrator has configured remote query authorisation for your voi-
cebox, you can query and configure your voicebox from an external telephone:
• Using the call number of OpenVoice / Aastra Voice (this number is included in
the incoming call distribution) …
you dial the MSN or the system number assigned by the system administrator to
the internal number of OpenVoice / Aastra Voice.
Z Enter the reserved call number.
Z Enter the system PIN.
* Press the star key.
Z Enter your internal call number.
# Press the hash key.
To Next Page
Loading...
