37Dialog 4224 Operator
Extending
Announce call
If you want to announce the call before extending (the terminal
must be in manual extending mode).
z Dial the extension number.
The right side of the display shows
EXTENSION and the called
extension’s number and name.
Speech >
Ò Press.
Speech > key lamp is switched on and the terminal rings the
extension.
Note: If the called extension is in a private network, there is
no need to press the Speech > key to call, as it is done
automatically.
When the called party answers,
ANSWER is shown.
Announce the call.
Note: System dependent, the calling party can listen to the
announcement.
ê
Press to extend the call.
The call is extended and the terminal is cleared.
Retrieve a call
It is possible to retrieve an extended call before it has been
answered, e.g. if you dialed a wrong number.
Ò < Clear Press.
You can also press the Clear > key. The display shows the data of
the extended call.
To correct the number:
Clear >
Ò Press.
Proceed to extend the call as normal.
To Next Page
Loading...
Need help?
General