Aastra TA7102i - Page 26

TA7102i Hardware Installation
© 2014 Aastra Sweden | 153_1531 ANF 90114| A | 2014-01-24 25
for details on the partial reset procedure. The corresponding link-local IPv6 address is also
available and printed on the sticker under the TA7102i.
Proceed with accessing the TA7102i’s web interface by using the unit’s link local address. The
unit’s link local address is printed on a sticker under the unit. The link local address can be
determined by using the following pattern: [fe80::290:f8ff:feXX:XXXX] where XXXXXX are the
last 6 digits of the unit’s MAC address. Example: The link local address for the TA7102i with
MAC address 00:90:F8:12:34:56 would be [fe80::290:f8ff:fe12:3456].
Note: On Windows, a scope ID needs to be added to the link local address
([fe80::290:f8ff:fe12:3456%11]). You can find this number by executing the ‘ipconfig’ command
in a command prompt. Note the number at
the end of the IPv6 default Gateway for the interface used to contact the unit.
On Linux, the scope identifier may be the link name or the interface number. The interface
number can be determined through the Linux command line.
Vocal Unit Information
When entering special characters on your telephone pad, the TA7102i talks back to you with
relevant information.
• To access vocal unit information:
1. Take one of the telephones connected to the TA7102i.
2. Dial one of the digits sequence on the keypad.
Table 4: Vocal Unit Information
Digits to Dial
Information Vocally Sent by the TA7102i
*#*0
Current IP address of the TA7102i (static or DHCP).
*#*1
MAC address of the TA7102i.
Verifying the Installation
There are a few ways to verify that the TA7102i is properly connected to the IP network and is
working:
• By contacting it with a SNMP browser
• By contacting it via the CLI
• By contacting it via a web browser
• By pinging it