Getting Started
1. To power-on a fully charged LED Pico+, hold down the power button for approxi-
mately three seconds until the projector turns on.
4
Powering ON the projector
Chapter 2
Powering OFF the projector
1. Press the power button once, then again to conrm.
2. After a few seconds, the unit should completely turn o.
1. Turn the LED Pico+ Projector completely o before charging.
2. Connect the USB-C end of the included Charge Cable to the DC port of the LED
Pico+ Projector.
3. Connect the USB end of the included Charge Cable to a power source. For continu-
ous operation, a USB charger with 5V/2A output is required.
Charging the projector
NOTE: The LED Pico+’s battery does not charge when it is in operation.
To Next Page
Loading...
