AAXA Technologies LED PICO + - Troubleshooting Image and Signal

Technical Details
IMAGE IS BLURRED
Possible Causes Solution
The Projector is not in focus. Adjust the focus with the focus adjustment dial
until the image comes into focus.
The Projector is o󰀨set from plane / angle of opera-
tion.
Move the projector so that it is both 180 degrees
and on an evern plane with the screen.
NO SYNC, NO SIGNAL
Troubleshooting
1. Be sure to setup the computer to enable a video signal output. On some
laptops this is done by pressing and holding Function F5 key. If using the LED
Pico+ as an external monitor on Windows based systems, this can be done by
selecting “extend my desktop to this monitor”. The native resolution of the LED
Pico+ projector is 1280x720. Depending on the video driver di󰀨erent resolu-
tions may need to be selected for proper output.
38