Manual Corrigo Ventilation, revision R Chapter 17 Configuration 103
The second line shows the present running status.
The third line shows the present temperature setpoint and actual values.
The fourth line shows the present SAF and EAF pressures.
15/03/2004 11:28
System: Running
Sp:22.0°C Act:21.8°C
SAF:1100Pa EAF:1050Pa
Type 4
The text on the first line can be changed using E tool
©
.
The second line shows the date and time.
The third line shows the present running status.
Vent unit 18 PX
2004-03-15 11:28
System: Running
Type 5
The text on the first line can be changed using E tool
©
.
The second line shows the date and time.
Vent unit 18 PX
2004-03-15 11:28
17.31.3 Automatic summer-/wintertime change-over
When Corrigo is set on automatic summertime/wintertime change-over, the timer will automatically
change between summertime and wintertime according to European standard.
Automatic summer/
winter time change
over
Yes
17.31.4 Address
Corrigo uses the addresses below when connecting to E tool
©
, and when multiple controllers are
connected in an EXO network. E tool
©
normally uses the addresses below, so if an address is
changed, the new address must also be entered in E tool
©
. If several Corrigo are connected in a
network, all the units must have the same ELA address, but each unit must have a unique PLA
address.
Address
PLA: 254
ELA: 254
17.31.5 Display anywhere (remote control)
If multiple Corrigo units are connected in a network, it is possible to remote control a unit in the
network from a unit with display. You do this by entering the address of the unit you wish to remote
control in the unit with display. The function is aborted by pressing the buttons UP, OK and DOWN
simultaneously.
To Next Page
Loading...