7. DiSEqC 1.1: Press the ◄/► button to select the required DiSEqC1.1 input.
8. Motor: Press the ◄/► button to select DiSEqC1.2 or USALS.
9. Scan Mode: Press the ◄ /► button to select scan mode.
10. Start search: Press the ◄/► button to select Satellite & Multi-Sat & Blind
scan & Transponder & Multi-Transponder which you want to start search.
3.1.1 Antenna Settings for Satellite
Press the ◄/► or OK button you can see the pre-stored Satellite list, in this
menu, you can execute select, Add, Move, Delete, Rename Satellites.
ØSelect
In this menu, you can press the ▲/▼ keys choose the satellite which you want
to use, and then press the OK to confirm the setting.
ØAdd
Press RED button to add a new
satellite. Here you can input
new
Satellite angle, Satellite
Direction (East, West), Band
(Ku, C). OK to
confirm the setting and this new satellite will be added to the end of the Satellite
list.
ØMove
In this menu, you can Select
the satellite that you want to
move from the satellite list
by pressing the GREEN button,
then press OK, you will be
asked to move the
satellite to put where, input the
destination number and press
OK. Then you can
To Next Page
Loading...
