ABB A150-M Series - Fig. 103: Fitting the Upper Fastening Strips; Fig. 104: Fitting the Bottom Fastening Strip; Table 66: Tightening Torque (51007)

Operation Manual / 4 Product description / A150-M56/66/57/67 -
A155-M..
11 Dismantling and fitting, special tools for fastening strips / 11.1 Ap-
plication, special tools
© Copyright 2020 ABB. All rights reserved. HZTL4032_EN Rev.P March 2020
Fitting the fastening strips
Fig.103: Fitting the upper fastening strips
Product Size Tightening torque [Nm]
A150 M16 175
A155 M16 175
Table66: Tightening torque (51007)
1. Fit the nuts (51007) of the (upper) fastening strips (51002) illustrated and tighten with a
torque spanner(02) without a spanner holder. Observe the tightening torque.
Fig.104: Fitting the bottom fastening strip
2. Position the collection tub(01) to catch any fixing elements if they fall.
3. Tighten the two nuts on one side by using the spanner holder(90165).
4. Tighten the two nuts on the other side by using the spanner holder(90166).
The cartridge group is fitted at this point in time. To enable a clear representation of the
work step, the cartridge group is not illustrated in work step5.
Page 137 / 171