1-12 ACH550-UH User’s Manual
Installation
Motor compatibility
The motor, drive, and supply power must be compatible:
Tools required
To install the ACH550 you need the following:
• Screwdrivers (as appropriate for the mounting hardware used)
• Wire stripper
• Tape measure
•Drill
• Frame sizes R5…R8 with UL type 12 enclosure: Punch for conduit mounting
holes
• Frame sizes R7/R8: pallet truck and hoist
• For installations involving frame size R6…R8: The appropriate crimping tool for
power cable lugs. See Power terminal considerations – R6 Frame size.
• Mounting hardware: screws or nuts and bolts, four each. The type of hardware
depends on the mounting surface and the frame size:
• For installations involving frame size R7…R8: Hoist.
Motor
Specification
Verify Reference
Motor type 3-phase induction motor –
Nominal current Motor value is within this
range: 0.15…1.5 * I
2N
(I
2N
= normal use current)
• Type code label on drive, entry for Output I
2N
,
or
• Type code on drive and rating table in
Technical data on page 1-297.
Nominal frequency 10…500 Hz –
Voltage range Motor is compatible with
the ACH550 voltage range.
208…240 V (for ACH550-xx-xxxx-2) or
380…480 V (for ACH550-xx-xxxx-4)
500…600 V (for ACH550-xx-xxxx-6)
Insulation 500…600 V drives: Either
the motor complies with
NEMA MG1 Part 31, or a
du/dt filter is used between
the motor and drive.
For ACH550-xx-xxxx-6
Frame Size Mounting Hardware Note
R1…R4 M5
#10
R5 M6 1/4 in
R6 M8
5/16 in
R7…R8 M10
7/16 Secures free standing cabinets if required.
To Next Page
Loading...
