2-92 ACH550 E-Clipse Bypass User’s Manual
Embedded fieldbus
Note: After any changes to the communication settings, the communication channel
must be reset by either cycling the system power, or by clearing (set to 0 and enter)
and then restoring the station ID (5002) to desired station ID.
Activate drive control functions – EFB
Controlling the drive
Fieldbus control of various drive functions requires configuration to:
• Tell the drive (via the bypass) to accept fieldbus control of the function.
• Define as a fieldbus input, any drive data required for control.
• Define as a fieldbus output, any control data required by the drive.
The following sections describe, at a general level, the configuration required for
each control function. For the protocol-specific details, see the specific protocol
technical data section in this manual.
5014 BP PAR14 Not used for Comm setup. Not Used
5016 BP PAR16 This parameter indicates
the count of MS/TP
tokens passed to the
unit.
5017 BP PAR17 This parameter works
with parameter 5011 to
set BACnet instance
IDs. See parameter
5011.
Bypass
Parameter
Description
EFB Protocol Reference
Modbus N2 FLN BACnet
To Next Page
Loading...
