ACH550-UH User’s Manual 1-19
Installation
• For details on control connections, refer to the following sections:
– Drive’s control connection terminals on page 1-316.
– Control connections on page 1-315.
– Application macros starting on page 1-49.
– Complete parameter descriptions on page 1-80.
– Embedded fieldbus on page 1-185.
– Fieldbus adapter on page 1-259.
• For electro-magnetic compliance (EMC), follow local codes and the requirements
in Motor cable requirements for CE & C-Tick compliance on page 1-311. For
example:
– Properly ground the wire screen cable shields.
– Keep individual un-screened wires between the cable clamps and the screw
terminals as short as possible.
– Route control cables away from power cables.
To Next Page
