ACH550 E-Clipse Bypass User’s Manual 2-13
Installation
Connection diagrams – Standard E-Clipse Bypass (wall mounted)
ACH550 Standard E-Clipse Bypass units are configured for wiring access from the
top. The following figure shows the Standard E-Clipse Bypass (wall mounted) wiring
connection points. Refer to the ACH550-UH User’s Manual on page 1-315 for
control connections to the drive.
ACH550
Motor
Input Power
Output Ground
Terminals
Terminals
Disconnect Switch
or Circuit Breaker
B1
Service Switch
(Optional)
E-Clipse Bypass
Control Board
Terminals X2
User Power
Cable Guides
Input Ground
Lug(s)
Lug
To Next Page
Loading...
