ABB ACS 400 - Page 10

viii ACS/ACH 400 Direct N2 Bus Interface
Chapter 3 – Installation
Introduction...................................................................... 3-1
Controlling the drive....................................................3-1
Feedback from the drive .............................................3-2
Hardware Installation....................................................... 3-2
Wiring..........................................................................3-2
Connections................................................................3-2
Grounding and Termination ........................................3-3
Chapter 4 – Programming
Programming of the Drive................................................4-1
Supported Features.........................................................4-1
Analog Input................................................................ 4-2
Binary Input.................................................................4-2
Analog Output.............................................................4-2
Binary Output.............................................................. 4-3
Communication Setup ..................................................... 4-3
Output Point Configuration ..............................................4-6
Analog Outputs ...........................................................4-6
Binary Outputs ............................................................4-7
Fault Queue.....................................................................4-8
Faults.......................................................................... 4-8
Chapter 5 – Fault Tracing
Fault Diagnostics.............................................................5-1
Normal operation ........................................................5-1
No Metasys station on line..........................................5-2
Duplicate station .........................................................5-2
Swapped wires............................................................5-2
Oem Application Fault.................................................5-2
Intermittent off-line occurrences..................................5-3
Metasys Commissioning.............................................5-3
Summary .........................................................................5-3
Appendix A – I/O Point List
Parameters......................................................................A-1
Appendix B – DDL File for NCU
ACH_400.DDL.................................................................B-1