Parameters
A-2 ACS/ACH 400 Direct N2 Bus Interface
Table A-1 I/O point list
Numb Point Units Range
Analog Inputs:
1 OUTPUT FRE- Hz 0 - 250
2 RATED SPEED % 0 – 100
3 SPEED rpm 0 – 9999
4 CURRENT A 0 – 9999
5 RATED TORQUE % -300 – 300
6 RATED POWER kW 0 -9999
7 DRIVE TEMPERA-
°C0 – 125
8 KILOWATT kWh 0 – 9999
9 MEGAWATT MWh 0 – 999
10 RUN TIME h 0 – 9999
11 DC BUS VOLT- V 0 – 999
12 PID-CTRL ACT % 0 – 100
13 LAST FAULT fault code
14 PREV FAULT fault code
15 OLDEST FAULT fault code
16 AI 1 ACTUAL % 0 - 100
17 AI 2 ACTUAL % 0 - 100
18 AO 1 ACTUAL mA 0 - 20
Binary Inputs:
1 STOP/RUN 0 = Stop, 1 = Drive Run-
2 FORWARD/ 0 = Forward, 1 = Reverse
3 OK/FAULT 0 = OK, 1 = Drive Faulted
4 RELAY OUTPUT 1 0 = off, 1 = on
5 RELAY OUTPUT 2 0 = off, 1 = on
6 DIGITAL INPUT 1 0 = off, 1 = on
7 DIGITAL INPUT 2 0 = off, 1 = on
To Next Page
Loading...
