ACS/ACH 400 Direct N2 Bus Interface B-1
Appendix B ā DDL File for NCU
This chapter lists the Data Definition Language
file for ACS/ACH 400 drives to be used with the
NCU units.
This chapter is intended for people who are
defining the I/O points of the ACS/ACH 400
drive to the Network Controller Units.
ACH_400.DDL
Below is the listing of the ACH_400.DDL file.
**********************************************
ABB Drives, ACH 400 Variable Frequency Drive
**********************************************
CSMODEL "ACH_400","VND"
AITITLE "Analog Inputs"
BITITLE "Binary Inputs"
AOTITLE "Analog Outputs"
BOTITLE "Binary Outputs"
CSAI "AI1",N,N,"FREQ ACT","Hz"
CSAI "AI2",N,N,"PCT ACT","%"
CSAI "AI3",N,N,"SPEED","RPM"
CSAI "AI4",N,N,"CURRENT","A"
CSAI "AI5",N,N,"TORQUE","%"
CSAI "AI6",N,N,"POWER","kW"
CSAI "AI7",N,N,"DRV TEMP","C"
CSAI "AI8",N,N,"ENERGY k","kWh"
CSAI "AI9",N,N,"ENERGY M","Mwh"
CSAI "AI10",N,N,"HOURS","h"
CSAI "AI11",N,N,"DC VOLT","V"
CSAI "AI12",N,N,"PID ACT","%"
CSAI "AI13",N,N,"LAST FLT","Code"
CSAI "AI14",N,N,"2ND FLT","Code"
To Next Page
Loading...
