ABB ACS 400 - Setting Parameter Value

Appendix B – DDL File for NCU
B-2 ACS/ACH 400 Direct N2 Bus Interface
CSAI "AI15",N,N,"1ST FLT","Code"
CSAI "AI16",N,N,"AI 1","%"
CSAI "AI17",N,N,"AI 2","%"
CSAI "AI18",N,N,"AO 1","mA"
CSBI "BI1",N,N,"STATUS","STOP","RUN"
CSBI "BI2",N,N,"DIRECT.","FWD","REV"
CSBI "BI3",N,N,"FAULT","OK","FLT"
CSBI "BI4",N,N,"RO 1","OFF","ON"
CSBI "BI5",N,N,"RO 2","OFF","ON"
CSBI "BI6",N,N,"DI 1","OFF","ON"
CSBI "BI7",N,N,"DI 2","OFF","ON"
CSBI "BI8",N,N,"DI 3","OFF","ON"
CSBI "BI9",N,N,"DI 4","OFF","ON"
CSBI "BI10",N,N,"DI 5","OFF","ON”
CSAO "AO1",Y,Y,"REF 1","%"
CSAO "AO2",Y,Y,"REF 2","%"
CSAO "AO3",Y,Y,"CURR LIM","A"
CSAO "AO4",Y,Y,"ACCEL 1","s"
CSAO "AO5",Y,Y,"DECEL 1","s"
CSAO "AO6",Y,Y,"PID GAIN","%"
CSAO "AO7",Y,Y,"PID ITIM","s"
CSAO "AO8",Y,Y,"PID DTIM","s"
CSAO "AO9",Y,Y,"PID DFIL","s"
CSAO "AO10",Y,Y,"CMD AO 1","%"
CSBO "BO1",Y,Y,"START","STOP","START"
CSBO "BO2",Y,Y,"REVERSE","FWD","REV"
CSBO "BO3",Y,Y,"PAN LOCK","OPEN","LOCKED"
CSBO "BO4",Y,Y,"RUN ENAB","DISABLE","ENABLE"
CSBO "BO5",Y,Y,"R1/2 SEL","EXT 1","EXT 2"
CSBO "BO6",Y,Y,"FLT RSET","-","RESET"
CSBO "BO7",Y,Y,"CMD DO 1","OFF","ON"
CSBO "BO8",Y,Y,"CMD DO 2","OFF",'ON"