CHAPTER 9 – CDP CONTROL PANEL 146
9.6.2 Enabling / unlocking a parameter lock
Unwanted parameter entry can be prevented by
activating the parameter lock function.
The corresponding parameters are 16.02 PARAME-
TER LOCK and 16.03 PASSCODE and belong to
parameter group 16 SYSTEM CTRL INPUTS.
Enabling the parameter lock
1. Select parameter 16.02 PARAMETER LOCK.
2. Set parameter 16.02 to LOCKED.
3. Save the setting and exit the parameter mode.
Unlocking the parameter lock
1. Select parameter 16.03 PASSCODE.
2. Set the correct pass code.
3. Save the setting and exit the parameter mode.
For further information, see
Signal and
parameter table.
To Next Page
Loading...
