158 ACS2000 DFE UM 3BHS360367 ZAB E01 REV. K
15.
(INU phase modules only)
When all cables have
been reconnected, check that the drive control
system and the phase module communicate
with each other. Switch on the auxiliary power
supply.
Check that the LEDs on the Phase-INT circuit
board of the phase module are on (see box in
the figure below).
16. Push the phase module back into the rack as far
as it goes and tighten the fastening bolt on
each side.
17. Remove the rails and reinstall the acrylic panel.
18. Switch on all miniature circuit breakers in the
control compartment.
The work is now completed, and the drive can be
started again.
For further information, see 8.6 Starting the drive.
To Next Page
Loading...
