Fault tracing 03
Viewing warning/fault information
The drive is able to store a list of the active faults actually causing the drive to trip at
the present time. The drive also stores a list of faults and warnings that have
previously occurred.
For each stored fault, the panel shows the fault code, time and values of nine
parameters (actual signals and status words) stored at the time of the fault. The
values for the latest fault are in parameters 05.80...05.88.
For active faults and warnings, see
• Menu - Diagnostics - Active faults
• Menu - Diagnostics - Active warnings
• Options - Active faults
• Options - Active warnings
• parameters in group 04 Warnings and faults (page 161).
For previously occurred faults and warnings, see
• Menu - Diagnostics - Fault & event log
• parameters in group 04 Warnings and faults (page 161).
The event log can also be accessed (and reset) using the Drive composer PC tool.
See Drive composer PC tool user’s manual (3AUA0000094606 [English]).
QR code generation for mobile service application
A QR code (or a series of QR codes) can be generated by the drive for display on the
control panel. The QR code contains drive identification data, information on the
latest events, and values of status and counter parameters. The code can be read
with a mobile device containing the ABB service application, which then sends the
data to ABB for analysis. For more information on the application, contact your local
ABB service representative.
To generate the QR code, select Menu - System info - QR code.
Note: If a control panel which does not support QR code generation (version older
than v.6.4x) is used, the QR code menu entry will disappear totally and will not be
available any longer either with control panels supporting the QR code generation.
To Next Page
Loading...
