ABB ACS580-01 Series - Mechanical Installation - Frames R1 to R3; Unpacking and Examining the Delivery

EN – R6…R9 Quick installation guide 17
R0-
R4
R6-
R9
R6-
R9
EN
DA
DE
ES
FI
FR
IT
NL
PL
PT
RU
SV
TR
ZHZH
Install optional modules, if any
See chapter Electrical installation in ACS580-01 (0.75 to 250 kW, 1.0 to 350 hp)
hardware manual (3AXD50000044794 [English]).
Install side plates and covers
See figure G on page 33.
IP21
1. Reinstall the side plates of the cable entry box (1a). Tighten the retaining screws
with a screwdriver (1b).
2. Slide the cover of the cable entry box on the module from below until the cover
snaps into place (2).
3. Reinstall the module cover (3a). Tighten the two retaining screws with a
screwdriver (3b).
IP55
1. Reinstall the module cover (1a). Tighten the two retaining screws with a
screwdriver (1b).
For start-up instructions, see chapter EN – Quick start-up guide on page 23