ABB ACS580-01 - Page 21

EN – Main switch and EMC C1 filter options installation supplement 21
EN
DA
DE
ES
FI
FR
IT
NL
PL
PT
RU
SV
TR
ZH
 R3…R4
Option layout
Options are shown with the covers removed in the following figures.
Connect the power cables
See the figures in section R3…R4 Figures on page 262. The figure numbers refer to
the step numbers.
1. Remove the rubber grommets from the cable entry.
2. Motor cable: Prepare the motor cable according to the R1…R5 quick installation
and start-up guide of the drive, except the text below in this step. See figure 2 in
section R3…R4 Figures on page 262.
+B056+F316, +B056+E223:
Lead the cable through the toroidal core.
Note: Do not strip the cable under the clamp (2a), otherwise the toroidal core
does not remove interference from the motor cable.
2T1 4T2 6T3
O
OFF
2
T
1
4T
2
R3…R4, +B056+E223
A1 Main switch
A2 Main switch auxiliary contact. Connector 13 at the bottom (A2a) and connector 14 on
the top (A2b).
B1 EMC C1 filter
B2 EMC C1 filter terminal block
B3 EMC C1 filter toroidal core
C Grounding terminal for the input cable
B1
B2
B3
O
OFF
2T1 4T2 6T3
2
T
1
4T
2
R3…R4, +B056+F278
A1
R3…R4, +B056+F316
A1
B1
B3
A2
A2b
A2a
A2
A2b
A2a
C C C