82 Installation of the ASTO board (Safe torque off, +Q967)
WARNING! The supply voltage for the ASTO-11C board is 24 V DC. If the
board is supplied with 230 V AC, the board is damaged and it needs to be
replaced.
The following figure shows how the external ASTO board is connected the drive. The
cable (length 3 m [10 ft]) is delivered with the ASTO board.
See
• page
70
for the location of terminal X41 of the drive.
• page 84 for the circuit diagram.
• page 160 for the dimensions of the ASTO-11C board.
• page 125
for the technical data of the ASTO-11C board.
To Next Page
Loading...
