ABB ACS850 - How to Select the Monitored Signals

Operation
27
How to select the monitored signals
7. • To continue, press .
• To cancel the new value and keep the original, press .
The new value is shown in the parameters list.
Step Action Display
1. You can select which signals are monitored in the Output mode and how they
are displayed with group 56 PANEL DISPLAY parameters. See page 21 for
detailed instructions on changing parameter values.
Note: If you set one of the parameters 56.01…56.03 to zero, in the output mode
you can see names for two remaining signals. The names are also shown, if
you set one of the mode parameters 56.04…56.06 to Disabled.
Step Action Display
SAVE
CANCEL
1407 DI02 out src
C.TRUE
1408 DI02 Ton
1409 DI02 Toff
1410 DI03 conf
PARAMETERS
EXIT
EDIT
00:00
LOC
5601 Signal1 param
PAR EDIT
01.03
CANCEL NEXT
00:00
LOC
5602 Signal2 param
PAR EDIT
01.04
CANCEL NEXT
00:00
LOC
5603 Signal3 param
PAR EDIT
01.06
CANCEL NEXT
00:00
LOC