ABB ACS850 - I;O Settings; How to Edit and Change Parameter Settings Related to I;O Terminals

Operation
42
I/O Settings
In the I/O Settings mode, you can:
• check the parameter settings related to any I/O terminal
• edit the parameter setting
• start, stop, change the direction and switch between local and remote control.
How to edit and change parameter settings related to I/O terminals
Step Action Display
1. Go to the Main menu by pressing if you are in the Output mode, otherwise
by pressing repeatedly until you get to the Main menu.
2. Go the I/O Settings mode by selecting I/O SETTINGS on the menu with keys
and , and pressing .
Select the I/O group, e.g. Digital inputs, with keys and .
3. Press . After a brief pause, the display shows the current settings for the
selection.
You can scroll digital inputs and parameters with keys and .
4. Press . The panel shows information related to I/O selected (in this case,
DI1).
You can scroll information with keys and .
Press to return to the digital inputs.
5. Select the setting (line with a parameter number) with keys and .
You can edit the parameter (INFO selection turns into EDIT selection).
6. Press .
MENU
EXIT
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT ENTER00:00
MAIN MENU 1
LOC
ENTER
Analog outputs
Analog inputs
Digital I/Os
Digital inputs
Relay outputs
EXIT
SEL
00:00
I/O SETTINGS 1
LOC
Analog outputs
Analog inputs
Digital I/Os
Digital inputs
Relay outputs
EXIT
SEL00:00
I/O SETTINGS 4
LOC
SEL
DI1
1002 Ext1 start in1
DI2
DI3
1010 Fault reset sel
I/O SETTINGS 1
LOC
EXIT INFO00:00
INFO
EXIT
LOC
EXIT
00:00
NUM OF I/O ITEMS
0
SLOT NUMBER
0
NODE NUMBER
I/O INFO
DI1
1002 Ext1 start in1
DI2
DI3
1010 Fault reset sel
I/O SETTINGS 1
LOC
EXIT EDIT00:00
EDIT
1002 Ext1 start in1
PAR EDIT
DI1
CANCEL SEL
00:00
[P.02.01.00]
LOC