CoriolisMaster FCB400, FCH400 CORIOLIS MASS FLOWMETER | CI/FCB400/FCH400-EN REV. H 27
3 Product identification
Name plate
Note
The name plates displayed are examples. The device
identification plates affixed to the device can differ from this
representation.
1 Type designation
2 CE mark
3 Serial number
4 Order code
5 Manufacturer
6 Process connection / pressure
rating
7 Ambient temperature range
8 PED marking
9 Maximum power consumption
j ‘Hot surface’ symbol
k ‘Observe operating instruction’
symbol
l Year of manufacture
(month / year)
m Ex marking, such as ATEX / IECEx
or FM / CSA
n Maximum voltage at inputs and
outputs
o Power supply
p IP rating
q Measuring medium temperature
range
r Meter tube material
s Nominal diameter
Figure 3: Name plate (example)
The marking is provided on the name plate and on the sensor
itself in accordance with the Pressure Equipment Directive
(PED).
1 CE mark with notified body
2 Serial number of the sensor
3 Fluid group or reason for
exception
4 Material of the pressure-bearing
parts (wetted parts)
5 Nominal diameter / Nominal
pressure rating
Figure 4: PED marking (example)
The marking is dependent on the nominal diameter (> DN 25 or
≤ DN 25) of the sensor (also refer to Pressure Equipment
Directive 2014/68/EU).
Pressure equipment within the scope of the Pressure
Equipment Directive
The number of the notified body is specified underneath the CE
mark to confirm that the device meets the requirements of the
Pressure Equipment Directive.
The respective fluid group in accordance with the Pressure
Equipment Directive is indicated under PED.
Example: Fluid Group 1 = hazardous fluids, gaseous.
Pressure equipment beyond the scope of the Pressure
Equipment Directive
In PED the exception to Article 4 (3) of the Pressure Equipment
Directive is specified.
The pressure equipment is classified in the SEP (= Sound
Engineering Practice) ‘Good Engineering Practice’ category.
To Next Page
Loading...
