CoriolisMaster FCB400, FCH400 CORIOLIS MASS FLOWMETER | OI/FCB400/FCH400-EN REV. E 97
Menu: Device Info
This menu is only used to display the device parameters. The parameters are displayed independently of the configured access level,
but cannot be changed.
Menu / parameter Description
Device Info
...Sensor Selection of submenu ‘...Sensor’ using .
...Transmitter Selection of submenu ‘...Transmitter’ using .
Device Info / ...Sensor
Sensor Type Sensor type.
Meter Size Nominal diameter of sensor.
Feature Series Sensor model. DensiMass and FillMass functions are only available in models FCB450 / FCH450.
Qm Max DN The value specifies the maximum flow rate. The value is set automatically via the selected nominal diameter.
Span Forward Calibration value (range) in the forward flow and return flow direction of the sensor.
Span Reverse
Zero Sensor Calibration value (zero point) of the sensor for the selected nominal diameter.
Freq.@ Empty Pipe Meter tube frequency and density during calibration with an empty or full meter tube. Calibration with an empty meter tube
is performed using air; calibration with a full meter tube is performed using water.
Density @ Empty Pipe
Freq.@ Full Pipe
Density @ Full Pipe
Sensor ID ID number of the sensor.
Sensor Serial No. Serial number of the sensor.
Sensor Run Hours Operating hours of the sensor.
...Calibration Selection of submenu ‘...Calibration’ using .
Device Info / ...Sensor / ...Calibration
First Cal. Date Date of first calibration of sensor (calibration of new device).
Last Cal. Date Date of last calibration of sensor.
Cal. Cert. No. Identification (number) of the relevant calibration certificate.
First Cal. Location Place of first calibration of the sensor.
Last Cal. Location Place of last calibration of sensor.
Menu / parameter Description
Device Info / ...Transmitter
Transmitter Type Type of transmitter.
Transmitter ID ID number of transmitter.
Transm.Serial No. Serial number of transmitter.
...Transmitter Version Selection of submenu ‘...Transmitter Version’ using .
Transm. Run Hours Run hours of the transmitter.
Tx Restart Counter Number of device restarts (switching the power supply off and on).
Time since Restart Device operating hours since the last restart.
Option Card Slot 1 Type of plug-in card present in slot OC1 / OC2.
If the plug-in card is incorrectly detected or incompatible, a corresponding message will be issued.
Option Card Slot 2
To Next Page
Loading...
