Lifting Instructions - AKD5 Emax2 600A Retrofill Breaker
A
Retrofi ll
Breaker
Fig. 1A
1. For A se KD5 AK25 Emax1.2 Retrofill Breaker, u
lifting device A as shown in Table 2 along with a
for ing.suitable hoist lift
2. Make sure the lifting device is secured and locked
with the hoist.
3. Lifting hooks (Item no.2, Table 2) can open in/out
within an angle of 7 in the vertical plane
± ° .
4. Lifting hooks can be engaged on the spreader bar
(Item no.1, Table 2) using any one of the two slots as per
the location of the hooking points in the Retrofill .Breaker
. Make sure that the 5 hooks are engaged in the slots
provided as shown in fig. 1C.
. the steady6 While lifting hold and Retrofill Breaker
c it ontinue to guide , while checking both sides and
both underneath, so that sets of pins can be lowered and
the of AKD6 switchgearlined up easily with rail slots .
. Once the is resting in the rail lots, 7 Retrofill Breaker s
lifting hooks and munhook the ove the hoisting apparatus
out of the way.
Lifting Instructions
Fig. 1A
*
* Refer Table 2
Fig. 1B
Fig. 1C
Lifting evices - Emax2 Retrofill ircuit reakers 600A-5000A ©2020 D C B 6
2TSA451029P0000 Rev-B