ENDURA AZ20 & AZ30 | OXYGEN ANALYZER | SI/AZ20/AZ30-EN REV. A
7
7 Configuration
This document does not replace the standard installation
manuals for the AZ20 or AZ30. For full details on how to safely
install and configure AZ20 and AZ30 probes, please refer to the
documentation listed in section 4 on page 5.
However, in this section are listed some areas that are not
absolutely necessary for operation, but can affect the safety
function.
Locking/unlocking the configuration level
SAFETY NOTE
Unauthorized changes of the parameter settings may affect
the safety function.
Once configuration is completed, the device must be
protected against unauthorized access.
Passwords can be set in Device Menu > Security setup.
Users with standard access can change the password for
standard users and users with advanced access can set
passwords for both standard and advanced users.
Security setup Used to set Standard and Advanced
level passwords of up to 6
alphanumeric characters.
Note. Standard and Advanced
passwords are not set at the factory
and must be set by the end-user(s).
None
Standard Set by Standard and Advanced users
Advanced Set by Advanced users
Reset password
If the password has been forgotten, there is an option to reset
it. Please refer to ABB to have your password reset.
To Next Page
Loading...
