8 | 2105515-001 rev. AB
3.5 Remove the IMV
1. Using a phillips screwdriver, remove the eight (8) mounting screws, washers
and lock washers, located on the bottom of the enclosure, that secure the IMV
to the µFLO cabinet (Figure 2). Be careful not to drop the screws.
IMV
assembly
(complete)
Optional I/O
expansion card
MMI connector
Lithium battery
Gasket
Liquid crystal
display
Battery
tray
Figure 2: µFLO IMV replacement (for illustrative purposes only)
2. Loosen the IMV by tilting it slightly forwards and then backwards. Carefully slide
the upper body of the assembly down through the bottom access cutout until
clear.
To Next Page
Loading...
