ABB HT557844 - Tables

Operation Manual / 4 Product description / A150-M.. - A155-M..
Tables
Page 119 /
120
© Copyright 2017 ABB. All rights reserved.
HZTL4032_EN
Revision F
January 2017
Tables
Table 1
Related documents .................
5
Table 2
Weights of turbocharger A150-
M.. – A155-M.. ........................
11
Table 3
Fitting the turbocharger, di-
mensions X, L .........................
17
Table 4
Pressure screw tightening
torques ...................................
19
Table 5
Lubricating oil pressure, oil
inlet .........................................
27
Table 6
Lubricating oil temperature at
the inlet ...................................
28
Table 7
Maximum lubricating oil tem-
perature at the outlet ...............
28
Table 8
Tightening torque (86505) .......
32
Table 9
Expected replacement inter-
vals .........................................
38
Table 10
Maintenance table ..................
41
Table 11
Parameters for wet cleaning of
compressor .............................
45
Table 12
Turbine wet cleaning, recom-
mended operating state ..........
48
Table 13
Wet cleaning of turbines, pa-
rameters for 1-nozzle cleaning
49
Table 14
Wet cleaning of turbines, pa-
rameters for 6-nozzle cleaning
49
Table 15
Value table for soaking ...........
56
Table 16
Malfunctions when starting –
Delayed start-up .....................
59
Table 17
Malfunctions when starting –
Vibrations ...............................
59
Table 18
Malfunctions when starting –
Rubbing of rotating parts .........
59
Table 19
Malfunctions during operation
– Lubricating oil pressure too
low ..........................................
60
Table 20
Malfunctions during operation
– Speed reduces .....................
60
Table 21
Malfunctions during operation
– Speed increases ..................
60
Table 22
Malfunctions during operation
–
Exhaust gas temperature too
high.........................................
61
Table 23
Malfunctions during operation
– Charge air pressure too low .
61
Table 24
Malfunctions during operation
– Charge air pressure too high
62
Table 25
Malfunctions during operation
– Engine performance losses ..
62
Table 26
Malfunction – Turbocharger
pumping ..................................
63
Table 27
Malfunction – Sporadic surge
blows ......................................
63
Table 28
Malfunctions when stopping –
Runout noises .........................
64
Table 29
Malfunctions when stopping –
Runout time too short ..............
64
Table 30
Malfunction of the speed
measurement system
– No
signal or poor signal amplitude
65
Table 31
Malfunction of the speed
measurement sys
tem – Meas-
ured speed too high ................
65
Table 32
Malfunction of the speed
measurement system
– Meas-
ured speed too low..................
65
Table 33
Swivel lifting eyes....................
69
Table 34
Weights of assemblies ............
70
Table 35
3 press-off screws ...................
75
Table 36
Press-off screws – gas outlet
flange ......................................
76
Table 37
Threaded rod, dimension X .....
81
Table 38
Permissible clearances A and
B .............................................
84
Table 39
Permitted nozzle ring com-
pression PD ............................
85
Table 40
Fitting the turbocharger, di-
mensions X,L ..........................
88
Table 41
Tightening torque (51007) .......
88
Table 42
Tightening torque (79041) .......
89
Table 43
Tightening torque (72011) .......
90
Table 44
Permissible clearances N and
R .............................................
91
Table 45
Tightening torque (72051) .......
92
Table 46
Tightening torque (51007) .......
96