Operation Manual / TPS44-H.. - TPS52-H..
Figures
© Copyright 2021 ABB. All rights reserved. HZTL4037_EN Revision F May 2021
Figures
Fig.1: Serial number(01) on the rating plate ........... 4
Fig.2: Layout and function of the turbocharger...... 6
Fig.3: Volatile Corrosion Inhibitor (VCI)................... 10
Fig.4: Package with hygrometer ............................... 11
Fig.5: Warning plate locations ................................... 16
Fig.6: Rating plate ........................................................ 17
Fig.7: Position of the rating plate ............................. 18
Fig.8: Attachment of loads on the crane hook ....... 19
Fig.9: Attachment angle.............................................. 19
Fig.10: Swivel lifting eyes........................................... 28
Fig.11: Removing the turbocharger.......................... 30
Fig.12: Inserting gaskets into the bracket............... 31
Fig.13: Inserting threaded rods into the bracket... 32
Fig.14: Requirements for threaded rods.................. 32
Fig.15: Placing the turbocharger on the bracket.... 33
Fig.16: Layout and overview of the speed measure-
ment system.................................................................. 42
Fig.17: Fitting the speed sensor ............................... 44
Fig.18: Noise insulation, bellows .............................. 46
Fig.19: Cleaning the filter silencer............................ 54
Fig.20: Cleaning the compressor casing, diffuser
mechanically.................................................................. 56
Fig.21: Cleaning the nozzle ring, turbine casing
mechanically................................................................... 57
Fig.22: Soaking contamination of the turbine....... 59
Fig.23: Swivel lifting eyes............................................ 71
Fig.24: Ring nuts........................................................... 72
Fig.25: Overview of assemblies ................................. 73
Fig.26: Removing the gas outlet casing.................. 74
Fig.27: Removing air inlets.......................................... 75
Fig.28: Removing the compressor casing (1/2) .... 76
Fig.29: Removing the compressor casing (2/2) .... 76
Fig.30 .............................................................................. 77
Fig.31: Do not loosen screw plugs............................. 77
Fig.32: Removing the cartridge group (1) ................ 78
Fig.33: Removing cartridge group2.......................... 78
Fig.34: Rotating the cartridge group and fitting the
service support .............................................................. 79
Fig.35: Removing the nozzle ring............................... 80
Fig.36: Measuring clearance A and B ........................ 81
Fig.37: Measuring nozzle ring compression ............ 82
Fig.38: Fitting the diffuser.......................................... 83
Fig.39: Lifting the cartridge group and rotating it
by 90° ............................................................................... 84
Fig.40: Fitting the cartridge group........................... 85
Fig.41: Installing the nozzle ring ................................ 86
Fig.42: Fitting the turbine casing.............................. 87
Fig.43: Rotating the turbocharger ............................ 88
Fig.44: Measuring clearances N and R...................... 89
Fig.45: Fitting the gas outlet casing......................... 90
Fig.46: Installing the air inlets.................................... 91
Fig.47: Overview of tightening torques ................... 92
Page 110 / 111Page 110 / 111
To Next Page
Loading...
Need help?
General
