ABB MNS iS - Page 49

M
M
N
N
S
S
i
i
S
S
S
S
y
y
s
s
t
t
e
e
m
m
S
S
e
e
t
t
u
u
p
p
2
2
ABB MNS iS System Setup & Operation Quick Guide / System Release 6.0 – Rev.2 / Aug. 2011
4
4
9
9
A parameterization window has different areas.
In the top area the MStart data is shown
(Consumer Id, MStart Id, Power and Current
Rating and Starter type). This data is not
editable, and is imported from the ABB
Engineering tool.
The area below is used for the firmware module
and its settings. Each firmware module has its
own window. Only those applications are
presented, which are available for the selected
MControl/MStart. Depending on the firmware
function the module has
 motor related parameters and
 configuration parameters
The change of configuration parameters alters
the functions of the MControl I/Os.
Figure 52 Parameterization window sections
Within the parameterization window it is possible
to toggle forwards and backwards with the arrow
keys on the right hand side of the window. This
will then display the list of parameters available
for the selected module. It is also possible to
select the required protection function by the
name tab.
To edit / enable / disable functions is simply a
matter of editing the values available in the fields,
moving the cursor over the field shows the
available values for that particular field.
Figure 53 Parameter list (example)
Once a field is edited and Apply is selected, the
information is saved within the MNavigate
package. The icon for the particular MControl in
the Tree View changes from the normal
MControl icon to the warning icon.
Now the parameters in the MNavigate differ from
those in the actual MControl.
User can now proceed to edit more parameters.
Each time a field is edited and shall be saved,
select ‘Apply’.
‘Cancel’ discards the data input.
‘OK’ closes the parameterization window
returning to the start page.
Figure 54 Saved parameters