ABB MNS iS - Page 61

M
M
N
N
S
S
i
i
S
S
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
3
3
ABB MNS iS System Setup & Operation Quick Guide / System Release 6.0 – Rev.2 / Aug. 2011
6
6
1
1
Relates to
Message
Motor Starter System
Alarm condition Trip condition
Motor Not Running X (X) X n.a. Contactor feedback after
ON command ok, but no
current detected
Suggested action:
 Check that motor cable
is connected to motor
and Power Condapter
terminals
 Check Motor
 Check that selected
Starter Type in MControl
application fits to real
Motor / Feeder
Application, e.g. NR-
DOL starter type
configured for an energy
distribution application.
Feedback
Supervision
(K1,K2,K3)
X X Contactor Feedback from
does not correspond with
motor status
Condition
Current as expected
Conta
ctor Feedback does
not correspond with motor
status
Condition
Even current not as
expec
ted
Suggested action:
 Check "CF Timeout"
parameter setting
 Check / Replace Power
Module
Test Mode Failure X n.a. MStart/ MFeed is in test
position but current
detected
Suggested action:
 Check / Replace Power
Module
Main Switch
Supervision
X Main switch off (motor not
running)
Note:
Alarm indication only if
Alarm parameter is set to
Enabled !
Main switch off while motor
is running
Note:
Trip only if Trip parameter
is set to Enabled !