Cold start:
cation is only possible if a correct parameter telegram was received. The parameter telegram is sent to the connected
Online reconfiguration:
accepted.
Reaction on wrong configuration telegrams: The wrong configuration or parameter telegrams can occur if the used GSD file
Online re-parameterization of devices:
lation of the user application in the master is usually not necessary. In some control systems, a restart of the master must be
mode.
•
be found in the documentation of this system.
• Sending new parameters during cyclic operation can be critical. If parameters are out of range or cannot be accepted from
Please consult the manual of the connected devices for more information.
Reaction on Wrong Parameter Telegrams:
cyclical operation mode and waits for a new parameter telegram.
V1 Requests from a Class1 Master:
V1 Requests from a Class2 Master:
lished to a slave simultaneously, are determined by the slave. PDP32 supports up to 3 concurrent class 2 connections.
—
For the PROFIBUS expert
13 UNIVERSAL MOTOR CONTROLLER UMC100.3
To Next Page
Loading...
