Need help?Do you have a question about the ABB PST and is the answer not in the manual?
General| Brand | ABB |
|---|---|
| Model | PST |
| Category | Controller |
| Language | English |
Provides step-by-step instructions for connecting the softstarter.
Guides the user through the initial configuration settings for the softstarter.
Explains how to start the motor using the softstarter.
General guidance on mounting the softstarter unit.
Describes the main electrical connection procedures for the softstarter.
Details how to connect the main power circuit in line or delta configurations.
Explains connections for control voltage and the control circuit.
Details the wiring for start/stop commands using internal or external control.
Outlines the two primary methods for performing settings and configuration.
Guides through setting predefined parameters for specific applications.
Covers essential start/stop parameters for quick setup.
Details parameters organized by function, for advanced setup.
Covers configuration of various protection functions like overload and locked rotor.
Explains how to set the rated motor current for the softstarter.
Details how to configure the motor start ramp time.
Explains how to set the motor stop ramp time for controlled stopping.
Sets the starting voltage level for the motor start ramp.
Sets the final voltage level where the stop ramp ends.
Sets the maximum current limit during motor start.
Configures the integrated motor overload protection function.
Enables and configures the locked rotor protection feature.
Configures the underload protection to prevent motor damage.
Sets up protection against phase current imbalances.
Configures protection against excessive motor current.
Enables protection against incorrect phase sequence.
Details the configuration for PTC thermistor motor protection.
Lists common problems, their possible causes, and solutions.
To Next Page
