ABB PST - Event Log Menu; Reset Events Menu; Status Information Menu

60 Low Voltage Products & Systems
AC 1006.9 - 5/03 ABB Inc. • 888-385-1221 • www.abb-control.com
Figure 25: Event log menu
Chapter 6 - Human-Machine Interface (HMI)
Figure 26: Status information menu
Figure 27: Reset events menu
6:2.5 Event Log menu
The Event Log menu is used to check the event log in the
softstarter. When entering this menu, the twenty latest
events in the log are presented, in chronological order with
the latest event as No. 1, the second latest as No. 2 etc.
The events are presented with “type of event”, date and
time.
Use the navigation keys to view all entries in the event log.
6:2.6 Status Information menu
The Status information menu is used to present various
information.
Use the navigation keys to cycle through the various sub
menus.
6:2.7 Reset Events menu
The Reset Events menu is entered automatically when a
fault has occurred or a protection is activated. It can also be
entered through the main menu.
Use the navigation keys to view all events. Each event can
be reset.
Display text Function
Connection
Type of connection, In
Line/Inside Delta.
Frequency Measured frequency.
Phase L1 Phase current L1.
Phase L2 Phase current L2.
Phase L3 Phase current L3.
RunTime Totalruntimeofthemotor.
No. Of Starts Run counter
SW Ver. CU Software version CU.
SW Ver. FU Software version FU.
LV Board No Serial No of the LV PCB.
MAC Address Internal addressing.
Phase seq. Phase sequence indication.
Top level
Settings
Local Control
Event Log
Status Information
Reset Events
Top level
Settings
Local Control
Event Log
Status Information
Reset Events
Top level
Settings
Local Control
Event Log
Status Information
Reset Events