1.2b Serial
connections
Capabilities Current
value
If configurable,
list methods
● Not checked Not
checked
○ No gap permitted
○ Fixed at bit times
○ Fixed at ms
○ Configurable, range ___ to ___ bit times
○ Configurable, range ____ to ____ ms
○ Configurable, Selectable from ___,___,___bit times
○ Configurable, Selectable from _ _ _ ms
○ Configurable, other, describe:
○ Variable, explain:
1.2.8 Inter-character gaps in transmission: When serial interfaces with asynchronous character framing are used, this parameter indicates
whether extra delay is ever introduced between characters in the message, and if so, the maximum width of the gap. Where no asynchronous
serial interface is fitted, this parameter is not applicable. In this case, none of the options shall be selected
● None (always transmits with no inter-character gap) None
○ Maximum _____ bit times
○ Maximum _____ ms
Table 5: IP networking
1.3 IP networking
Capabilities Current value If configurable, list
methods
1.3.1 Port Name: name
used to reference the
communications port
defined in this section
Both back-ports
1.3.2 Type of end point:
○ TCP Initiating (Master Only) TCP listening
● TCP Listening (Outstation Only)
○ TCP Dual (required for Masters)
● UDP Datagram (required)
1.3.3 IP address of this
device:
*.*.*.* PST or LHMI
1.3.4 Subnet mask: *.*.*.* PST or LHMI
1.3.5 Gateway IP
address:
*.*.*.* PST or LHMI
1.3.6 Accepts TCP connections or UDP datagrams from:
Table continues on next page
1MRK 511 419-UUS A Section 3
DNP3 protocol implementation
650 series 2.2 ANSI 33
Point list manual
To Next Page
Loading...
