ABB rec670 - Page 55

The mode for single command is set here.
Logic rotating switch SLGGIO
Main menu/Settings/General settings/Control/Commands/
SelectorSwitch(GGIO)/SL
A number of selector switches SLGGIO can be configured in the system. These are
substitutes for rotating physical switches. The parameter setting StopAt Extremesis
used to disable or enable the end position of the switch.
Versatile switch VSGGIO
Main menu/Settings/General settings/Control/Commands/VersatileSwitch/VS
Parameters such as control model according to IEC61850 and operation mode for
the versatile switch is set here.
Tap changer control and supervision TCMYLTC
Main
menu/Settings/General settings/Control/TransformerTapControl(YLTC,
84)/TCM
Tap changer parameters such as tap positions for low and high voltage and type of
code conversion are set here.
Tap changer control and supervision TCLYLTC
Main menu/Settings/General settings/Control/TransformerTapControl(YLTC,
84)/TCL
Tap changer parameters such as tap positions for low and high voltage and type of
code conversion are set here.
Automatic voltage control for tapchanger, parallel control TR8ATCC
Main menu/Settings/General settings/Control/
TransformerVoltageControl(ATCC,90)/VCP
Transformer voltage control parameters such as transformer name, transformer
reactance and selections for alarm and block functions are set here.
Automatic voltage control for tapchanger, single control TR1ATCC
Main menu/Settings/General settings/Control/TransformerVoltage
Control(ATCC,90)/VCS
Transformer voltage control parameters such as transformer name, transformer
reactance and selections for alarm and block functions are set here.
1MRK 511 188-UEN C Section 9
Read and change settings
49
Operator's manual