Need help?Do you have a question about the ABB REF 542plus and is the answer not in the manual?
General| Category | Control Unit |
|---|---|
| Frequency | 50/60 Hz |
| Display | LCD |
| Communication Protocols | IEC 61850, Modbus, DNP3 |
| Inputs | Digital and Analog |
| Outputs | Relay Outputs |
| Power Supply | 24-48 V DC / 100-240 V AC |
| Protection Functions | Overcurrent, Earth Fault |
| Protection Degree | IP20 |
| Storage Temperature | -40°C to +70°C |
| Humidity | 5 to 95 % non-condensing |
Manual overview and purpose.
List of related product documents and their IDs.
Section of HMI for primary object control and related information.
Section of HMI for information display and menu navigation.
Step-by-step guide to switch between control modes using E-Key.
Steps to acknowledge and reset alarms.
Procedures for modifying protection parameters and modes.
Displays analog measurements during commissioning.
Setting analog output values during commissioning.
Process of transferring configuration files to the unit via PC.
Explains common error messages and troubleshooting steps.
Details on connecting analog input signals.
Information on connecting digital I/O modules.
Menu for accessing service-related information.
Details on software fault levels and handling.
Steps to set up IP properties for Telnet connection.
To Next Page
