ABB REF 542plus - HMI Communication Page

99
A051653
Fig. 20.6.4.5.-5 CAN communication port subpage
20.6.4.6. HMI communication page
In this page, it is possible to change the Base Unit slave address used to
communicate with the HMI.
When the Base Unit address is changed, the communication with the
HMI is lost. To restore it, the Base Unit address must be inserted in the
HMI as well. Select the menu item Base Unit Slave Address and insert
the same address of the Base Unit.
Multifunction Protection and Switchgear Control Unit
Operator's manual
REF 542plusREF 542plus
1MRS755869