ABB REF630 - Page 10

Activating the test mode................................................................... 24
Preparing the connection to the test equipment............................... 25
Connecting test equipment to the IED..............................................25
Releasing the function to be tested.................................................. 26
Verifying analog primary and secondary measurement................... 26
Testing the protection functionality................................................... 28
Section 5 Troubleshooting .............................................................29
Fault tracing......................................................................................29
Identifying hardware errors..........................................................29
Identifying runtime errors.............................................................29
Identifying communication errors.................................................29
Checking the communication link operation...........................30
Checking the time synchronization.........................................30
Running the display test.............................................................. 31
Indication messages.........................................................................31
Internal faults............................................................................... 31
Warnings..................................................................................... 32
Additional indications...................................................................32
Correction procedures...................................................................... 33
Factory settings restoration......................................................... 33
Changing and setting the password............................................ 33
Identifying IED application problems........................................... 33
Inspecting the wiring...............................................................34
Inspecting the RTD wiring...................................................... 37
Section 6 Glossary......................................................................... 43
Table of contents
2 630 series
Commissioning Manual