ABB REF630 - Default Chapter; Table of Contents

Table of contents
Section 1 Introduction.......................................................................3
This manual........................................................................................ 3
Intended audience.............................................................................. 3
Product documentation.......................................................................4
Product documentation set............................................................4
Document revision history............................................................. 4
Related documentation..................................................................5
Symbols and conventions...................................................................5
Symbols.........................................................................................5
Document conventions.................................................................. 5
Functions, codes and symbols...................................................... 6
Section 2 Starting up......................................................................11
Factory and site acceptance testing................................................. 11
Commissioning checklist.................................................................. 11
Checking of the power supply.......................................................... 12
Energizing the IED............................................................................12
Checking the IED operation.........................................................12
IED startup sequence ................................................................. 12
Setting up communication between PCM600 and the IED...............13
Writing an application configuration to the IED.................................14
Checking CT circuits.........................................................................15
Checking VT circuits.........................................................................16
Checking the RTXP test switch ....................................................... 16
Checking transducer circuits............................................................ 17
Checking binary input and output circuits.........................................17
Checking binary input circuits......................................................17
Checking binary output circuits....................................................17
Checking RTD inputs and mA outputs............................................. 18
RTD input circuits........................................................................ 18
mA outputs circuits...................................................................... 18
Checking optical connections........................................................... 19
Section 3 Establishing connection and verifying the station
communication............................................................... 21
Setting the station communication....................................................21
Verifying the communication............................................................ 21
Section 4 Testing IED operation.....................................................23
Preparing the IED to verify settings.................................................. 23
Table of contents
630 series 1
Commissioning Manual