Table 101. Connector sets
Item Order number
Connector set for one 4U half 19" housing IED including analog
input variant 4I + 5U (Io 1/5A), 5I + 4U (Io 0.1/0.5A) or 4I + 5U (Io
0.1/0.5A)
2RCA021735
24. Tools
The IED is delivered either with or without
an optional factory made preconfiguration.
The default parameter setting values can be
changed from the front-panel user interface,
the web-browser based user interface
(WebHMI) or the PCM600 tool in
combination with the IED specific
connectivity package.
PCM600 offers extensive IED configuration
functions such as IED application
configuration, signal configuration, DNP3
communication configuration and IEC 61850
communication configuration including
horizontal communication, GOOSE.
When the web-browser based user interface
is used, the IED can be accessed either
locally or remotely using a web browser (IE
7.0 or later). For security reasons, the web-
browser based user interface is disabled by
default. The interface can be enabled with
the PCM600 tool or from the front panel user
interface. The functionality of the interface is
by default limited to read-only, but can be
configured to enable read and write access by
means of PCM600 or the local HMI.
The IED connectivity package is a collection
of software and specific IED information,
which enable system products and tools to
connect and interact with the IED. The
connectivity packages reduce the risk of
errors in system integration, minimizing
device configuration and set-up times.
Table 102. Tools
Configuration and setting tools Version
PCM600 2.1
Web-browser based user interface IE 7.0 or later
REF630 Connectivity Package 1.0 or later
Feeder Protection and Control 1MRS756380 A
REF630
Product version: 1.0 Issued: 15.09.2009
68 ABB
To Next Page
Loading...
