ABB REL 551 2.3 Series - Page 123

117
Thermal overload protection (THOL) &KDSWHU
9HULI\LQJVHWWLQJVE\VHFRQGDU\
LQMHFWLRQ
 7KHUPDORYHUORDGSURWHFWLRQ7+2/
Prepare the terminal for verification of settings as outlined in section “Preparing for
test” in this chapter.
Check that the input logical signal THOL-BLOCK is logical zero and note on the local
HMI that the logical signal THOL-TRIP, THOL-START and THOL-ALARM are
equal to the logical 0. Logical signals for thermal overload protection are available un-
der menu tree:
6HUYLFH5HSRUW)XQFWLRQV7KHUP2YHU/RDG)XQF2XWSXWV
 0HDVXULQJWKHRSHUDWHDQGWLPHOLPLWRIVHWYDOXHV
 7HVWLQJWKHSURWHFWLRQZLWKRXWH[WHUQDOWHPSHUDWXUHFRPSHQVDWLRQ1RQ&RPS
3URFHGXUH
 4XLFNO\VHWWKHPHDVXUHGFXUUHQWIDXOWFXUUHQWLQRQHSKDVH
WRDERXWRI,EWRPLQLPLVHWKHWULSWLPHDQGVZLWFKRII
WKHFXUUHQW
 5HVHWWKHWKHUPDOPHPRU\XQGHUPHQXWUHH
7HVW7KHUP5HVHW
 6ZLWFKRQWKHIDXOWFXUUHQWDQGUHDGWKHSUHVHQWHGWHPSHUD
WXUH
6HUYLFH5HSRUW)XQFWLRQV7KHUP2YHUORDG7KHUP2YHUORDG7/LQH
 &KHFNWKH$ODUPOLPLW7$ODUPGXULQJLQMHFWLRQ
Measure the signal THOL-ALARM until it appears on the corre-
sponding binary output or on the local HMI unit.
 &RPSDUHWKHPHDVXUHGWHPSHUDWXUHZLWKWKHVHWWLQJ
 0HDVXUHWKHWULSWLPHRIWKH7+2/SURWHFWLRQ
Use the THOL-TRIP signal from the configured binary output to
stop the timer.
 7DNHWKH³7/LQH´UHDGLQJV
Compare with the setting of TTrip.