ABB REL 551 2.3 Series - Overview

60
Overview &KDSWHU
6HWWLQJDQGFRQILJXULQJWKHWHUPLQDO
2YHUYLHZ
The customer specific values for each setting parameter and a configuration file has to
be available before the terminal can be set and configured, if the terminal is not deliv-
ered with a configuration.
Use the CAP 531 configuration tool to verify if the terminal has the expected configu-
ration. A new configuration is performed with the CAP tool. The binary outputs can be
selected from a signal list where the signals are grouped under their function names. It
is also possible to specify a user-defined name for each input and output signal.
The configuration can be downloaded through the front connector on the local HMI or
via the rear SPA port.
Each function included in the terminal has several setting parameters which has to be
set in order to make the terminal behave as intended. A default value is provided for
each parameter from factory. A setting file can be prepared using the parameter setting
tool (PST), which is available in the CAP 540 package.
All settings can be:
• Entered manually through the local HMI.
• Downloaded from a PC, either locally or remotely using SMS/SCS. Front or rear
port communication has to be established before the settings can be downloaded.
1RWH
%HVXUHWRFRQILJXUHWKHIXQFWLRQDOLQSXW+0,%/2&.6(7WRRQO\RQHRIWKHDYDLODEOH
ELQDU\LQSXWVEHIRUHVHWWLQJWKHSDUDPHWHU6HWWLQJ5HVWULFWWR%ORFNLQWKHORFDO+0,