ABB REL 551 2.3 Series - Entering Settings

67
Entering settings &KDSWHU
(VWDEOLVKLQJFRQQHFWLRQDQG
YHULI\LQJWKH63$,(&
FRPPXQLFDWLRQ
3URFHGXUH
 6HWWKHRSHUDWLRQRIWKHUHDU63$,(&SRUWWR³,(&´
The operation of the rear SPA/IEC port can be found on the local
HMI at:
&RQILJXUDWLRQ7HUPLQDO&RP63$,(&3RUW
 6ZLWFKWKHWHUPLQDORIIDQGRQ
Now the SPA/IEC port operates as an IEC port.
 6HWWKHVODYHQXPEHUDQGEDXGUDWHIRUWKHUHDU,(&SRUW
The slave number and baud rate can be found on the local HMI at:
&RQILJXUDWLRQ7HUPLQDO&RP,(&&RP&RPPXQLFDWLRQ
Set the same slave number and baud rate as set in the IEC master
system for the terminal.
 6HWWKHPDLQIXQFWLRQW\SHRIWKHWHUPLQDO
The main function type can be found on the local HMI at:
&RQILJXUDWLRQ7HUPLQDO&RP,(&&RP)XQFWLRQ7\SH
The main function type can be set to values from 1 to 255 accord-
ing to the standard. The value zero is default and corresponds to
not used. Examples of values that can be used are:
7DEOH 0DLQIXQFWLRQW\SHH[DPSOHV
If the setting “OpFnType” is set to “ON” then the set value for
function type will be used for all event blocks and the disturbance
recorder, otherwise the setting on each event block and the distur-
bance recorder will decide the function type of that function block.
9DOXH )XQFWLRQW\SHDFFRUGLQJWR,(&
128 Distance protection
160 Overcurrent protection
192 Line differential protection